• Tribe MFG JK Molle Panel Front Para Panel Part No. TRB-MP-JK-PPK2 Download Installation Manual T-16 Para Panel Molle Panel The Para Panels are the perfect solution for Molle overhead storage, accessible from your seat, front and back. The front Para Panel is pre-drilled for Race Radios, Cb’s and microphone hooks.  Para Panel install involves drilling and setting nutzerts but don’t interfere with any type of tops.  Front and rear sold separately.
  • Tribe MFG JK Molle Panel Tail Gunner Kit Part No.  TRB-MP-JK-TGK Download Installation Manual T-16 Tail Gunner Molle Panel The Tail Gunner panel hangs right on your tailgate, ready access to your tools for that trail repair, camp set up or fire extinguisher. The Tail Gunner requires drilling and setting of nutzerts but is a straight forward install with all hardware included.
  • Tribe MFG JK Molle Panel Tac Back 1 Ea. Part No. TRB-MP-JK-TBK Download Instruction Manual T-16 Tac-Back Molle Panel The Tac-Back is the simplest Molle panel, simply slipping over your seats head rest and securing at the base with a bungy under your seat.  Quick access to your easily organizable and infinitely customizable storage bags and pouches, right behind your seat. Sold Individually, one panel, one seat.
  • Tribe MFG JL Molle Panel Flank Panel Kit Part No. TRB-MP-JL-FPK Download Installation Manual T-16 Flank Panel Molle Panel The Flank Panel utilizes a very large mostly unused space in the rear of your vehicle and mounts directly to the roll cage, no drilling on this one.  Store those larger bags, bigger flash lights or that shovel you need for setting up a proper camp. Use the inner side during hard top season or both sides for maximum storage if you are going topless.  Flank Panels are sold in pairs.
  • JK Coil Over Towers         Part No. TRB-S-JK-ST Built for use with:
    • 12 In Coil Overs
    • 1.5” Spacing for
      • ​2.5” Coil Overs
      • ​2.0” Coil Overs with Wide Spacers
      • ​ORI Struts with spacers for 1.5”
    3.5-4” Lift Built in tab for limiting strap Fully welded upper tower Lower mount bolt re-oriented to eliminate binding Leaves room for 2” air bump   This is a weld on kit and will require welding and cutting, different combinations may require more fabrication.   The stock shock and coil mount will need to be removed from the frame and the inner fender liner will need to be modified for tower clearance.  This kit works with stock axles as well as aftermarket heavy duty setups.


Go to Top